Cali-GrafCali-Graf
DataProductionPanelsWeatherDesign

Heat derate in the Inland Empire and Valley by month

Cali-Graf · Published Nov 19, 2026 · Data as of Nov 18, 2026

Hot panels make less power, and in Southern California the loss peaks in late summer: in August at six of the seven sites we modeled, in July in Lancaster. In our model, a common panel with a -0.36%/°C coefficient lost 6.0% of its yearly output to heat in Santa Monica and 7.4% in Fontana, against what it would make with its cells at 25 °C. In August the loss reached 11.1% in Valencia and 10.9% in Lancaster; in a Lancaster December it was only 0.9%. A panel with a -0.25%/°C coefficient cut the Lancaster loss from 7.1% to 4.8% over the year and from 10.9% to 7.5% in August.

11.1%
August heat loss, Valencia
Common panel, south, 20°
7.4%
Yearly heat loss, Fontana
Same panel
31%
Lancaster: heat loss cut by a −0.25%/°C panel
Against a −0.36%/°C panel
In this guide
Heat loss by monthWhat the months sayWhat it means for the designData limitsQuestionsMethodologySourcesHow to cite this page

Heat loss by month#

MonthSanta MonicaWest CovinaVan NuysValenciaLancasterRiversideFontana
January3.4%4.0%2.8%2.6%1.7%4.1%4.0%
February4.0%4.7%3.9%3.4%3.1%4.8%4.7%
March5.1%5.8%4.0%5.4%5.1%4.9%5.4%
April5.9%6.5%5.0%5.2%6.2%6.6%6.6%
May5.5%7.0%6.0%8.2%7.9%7.5%7.7%
June6.6%7.7%8.0%9.2%9.7%8.0%8.8%
July7.8%9.2%8.6%10.0%10.9%9.8%9.6%
August8.3%9.9%9.3%11.1%10.9%10.2%10.1%
September7.2%9.4%8.8%9.4%9.7%9.2%9.3%
October6.7%8.0%7.9%7.9%7.2%9.1%9.2%
November5.2%5.9%4.9%5.2%4.0%5.7%5.7%
December2.9%2.5%1.8%2.0%0.9%2.6%2.4%
Year6.0%7.1%6.4%7.2%7.1%7.3%7.4%

Share of the panels' DC output lost to heat, net of the cool hours when cells run below 25 °C, by month, for Qcells Q.PEAK DUO BLK ML-G10 410 (-0.36%/°C) facing south at 20° on a roof: the CEC panel model at the modeled cell temperature against the same panel with its cells held at 25 °C, under the same sunlight. Typical-year weather (NSRDB) at Santa Monica 90401, West Covina 91790, Van Nuys 91406, Valencia 91355, Lancaster 93535, Riverside 92503 and Fontana 92335. Source: Cali-Graf engine.

Download this table (CSV)

Model the panel's heat loss at the customer's site
Cali-Graf models cell temperature and panel output hour by hour from the site's own weather.
Open Cali-Graf

What the months say#

- Late summer is the worst. August had the largest loss at every site but Lancaster, where July was slightly worse. - The coast loses least. Santa Monica's cool air kept its yearly loss to 6.0% and its August loss to 8.3%. - Valleys and the Inland Empire are alike. West Covina, Valencia, Riverside and Fontana all lost 7.1% to 7.4% a year; Van Nuys, at 6.4%, was closer to the coast in this weather year. - The desert swings the most. Lancaster's cells reached 77 °C in the model, but its cold winters cut the loss to 0.9% in December.

What it means for the design#

- A better coefficient cuts the heat loss by about a third everywhere. The better panel cut the yearly heat loss in Lancaster by 31%; it lost 1.9% less of its yearly output in Santa Monica and 2.3% less in Fontana, so the gain is a little larger where it is hot. - Model the heat by month. A yearly derate hides the summer: Lancaster's August loss was 1.5 times its yearly figure.

Data limits#

The loss is computed on the panels' DC output against a 25 °C reference under the same sunlight; it does not include the inverter, wiring or soiling. One typical weather year per site; heat waves make single months worse. All figures use the roof-mount cell temperature model. Two panels only; other panels fall between and around them according to their coefficients. The newer Q.PEAK DUO BLK ML-G10+ 410 is listed by the CEC with a better coefficient than the ML-G10 410 modeled here.

How much do solar panels lose in the heat in Southern California?

In our model, a common panel lost 6.0% of its yearly output to heat on the coast and up to 7.4% inland, and up to 11.1% in August.

Which month has the biggest heat loss?

August at six of the seven sites we modeled; in Lancaster, July by a small margin.

Does a better temperature coefficient help in the Inland Empire?

Yes: in Fontana a -0.25%/°C panel lost 5.1% a year against 7.4% for a -0.36%/°C panel.

Methodology#

The Cali-Graf engine takes the sunlight reaching each panel and its cell temperature hour by hour from PySAM's PVWatts model (roof mount) on NSRDB typical-year weather, then computes the panel's DC power with the CEC single-diode model from the panel's CEC parameters, once at the modeled cell temperature and once at 25 °C. The monthly loss is one minus the ratio of the two monthly sums. Rounded half up.

Sources#

  1. California Energy Commission — Solar Equipment Lists, PV modules. https://solarequipment.energy.ca.gov/
  2. NLR — PySAM, the Python package for the System Advisor Model. https://nrel-pysam.readthedocs.io/
  3. NLR — National Solar Radiation Database (NSRDB), typical meteorological year. https://nsrdb.nlr.gov/

How to cite this page#

Cali-Graf. “Heat derate in the Inland Empire and Valley by month.” cali-graf.com, updated Nov 19, 2026. https://cali-graf.com/guides/heat-derate-in-the-inland-empire-and-valley-by/