Cali-GrafCali-Graf
ReferenceTax creditsDomestic contentLeases and PPAsEquipment

Domestic content: which panels, inverters and racking qualify

Cali-Graf · Published Nov 18, 2026 · Data as of Nov 18, 2026

The domestic content bonus adds to the clean electricity investment credit (section 48E) that the owner of a leased or PPA home system claims; a homeowner who buys a system gets no federal credit after 2025. For a home-size system it adds 10 percentage points if the system's manufactured products reach a set share of U.S. content by cost: 50% for construction beginning in 2026, up from 45% in late 2025 and 40% before that. Under the IRS safe harbor, the cost shares are fixed per product, and the module decides the result. U.S.-made inverters and racking carry only 44.4% of a rooftop system with microinverters, short of 2026's 50%. A module made in the U.S. from U.S. cells and wafers carries 63.9% on its own.

50%
U.S. share of product costs needed for construction starting in 2026
48E domestic content bonus
44.4%
Share carried by inverters and racking, microinverter rooftop system
IRS safe harbor cost shares
63.9%
Share carried by a module with U.S. cells and wafers
Same table
In this guide
The ruleWhat each product carriesWhat installers should keepData limitsQuestionsMethodologySourcesHow to cite this page

The rule#

- What it adds. The bonus raises the credit rate by 10 percentage points when the project also meets the increased-credit requirements, which a facility under 1 MW AC does; otherwise it adds 2 points. - What is required. The owner certifies that any steel, iron or manufactured product that is a component of the facility was produced in the United States, under an adjusted percentage for manufactured products. The required share of costs depends on when construction began: 40% on or before June 15, 2025, 45% from June 16 to December 31, 2025, and 50% in 2026. - The safe harbor. Instead of the actual costs, the owner may use the cost shares the IRS assigned to each product and component in Notice 2025-08. For a rooftop system there are separate tables for microinverters or optimizers and for string inverters, and for modules made with U.S. cells and wafers.

Keep the equipment list with every design
Cali-Graf records the modules, inverters and batteries of each design, ready for the system owner's documentation.
Open Cali-Graf

What each product carries#

Made in the U.S.Microinverters or optimizersAt least 50%String inverterAt least 50%
Inverters and racking made in the U.S., modules imported44.4%No30.8%No
Modules made in the U.S. with U.S. cells and wafers, inverters and racking imported63.9%Yes75.9%Yes
Modules with U.S. cells and wafers and U.S. racking, inverters imported79.9%Yes95.0%Yes
Everything made in the U.S.100.0%Yes100.0%Yes

Domestic cost percentage of a rooftop solar system under the cost shares of the "Updated Table for Solar PV Rooftop" of Notice 2025-08. Where the modules use U.S. c-Si cells made exclusively from U.S. wafers, the table's columns for that case are used; otherwise the standard columns (Notice 2025-08, section 8.03(4)). A product's production cost counts only when all of its listed components are made in the U.S.; racking in this table is non-steel. Threshold: 50% for construction beginning in 2026. Source: IRS Notice 2025-08 and Instructions for Form 3468.

Download this table (CSV)

- Cells are the largest single item. They carry 31.1% of a microinverter system and 38.5% of a string system in the standard columns. A module assembled in the U.S. from imported cells does not count its production cost, because not all its components are domestic. The columns for U.S. cells and wafers apply only to cells made exclusively from U.S. wafers; an owner who uses them must treat U.S.-made cells on imported wafers as foreign and cannot count the production cost of the modules that contain them. - Electronics and racking are not enough in 2026. U.S.-made inverters and racking reach 44.4% with microinverters and 30.8% with a string inverter. The microinverter share would have met the 40% threshold for construction started by June 15, 2025; neither meets 2026's 50%.

What installers should keep#

- Where each product was made. For each product, keep records of where the product and its listed components were made; Notice 2023-38 sets the recordkeeping rules, and the owner's certification rests on them. - The start date. Keep the date construction began, since the threshold depends on it. - The owner's attachment. The owner attaches a domestic content certification statement to Form 3468 for each project.

Data limits#

The table applies the IRS's assigned cost shares to whole products; a real calculation follows Notice 2023-38, Notice 2024-41 and Notice 2025-08 component by component. Which brands meet the requirement depends on each manufacturer's supply chain and is not assessed here. The bonus is separate from the foreign entity rules, which can deny the credit altogether, and from the deadline for solar: a facility placed in service after 2027 keeps the 48E credit only if construction began by July 4, 2026. This is not tax advice.

What is the domestic content threshold for solar in 2026?

For the 48E credit, 50% of the total cost of manufactured products must be U.S.-made for construction beginning in 2026, against 45% from June 16 to December 31, 2025.

Do U.S.-made inverters qualify a home solar system for the domestic content bonus?

Not on their own in 2026: under the IRS rooftop safe harbor, inverters and racking together carry 44.4% of a microinverter system's cost, below 50%.

Who gets the domestic content bonus on residential solar?

The business that owns a leased or PPA system and claims the 48E credit; homeowners who buy a system get no federal credit after 2025.

Methodology#

The rules are quoted from the IRS Instructions for Form 3468 and Notice 2025-08, saved on November 18, 2026. Each product's share is the sum of its listed components and production cost in the "Updated Table for Solar PV Rooftop"; in the published table, the footnote mark of the production row is not part of the number, and each column sums to 100. Shares are rounded half up.

Sources#

  1. Internal Revenue Service — Notice 2025-08, updated elective safe harbor for domestic content. https://www.irs.gov/pub/irs-drop/n-25-08.pdf
  2. Internal Revenue Service — Instructions for Form 3468. https://www.irs.gov/instructions/i3468
  3. Internal Revenue Service — Notice 2025-42, beginning of construction for wind and solar facilities. https://www.irs.gov/pub/irs-drop/n-25-42.pdf

How to cite this page#

Cali-Graf. “Domestic content: which panels, inverters and racking qualify.” cali-graf.com, updated Nov 18, 2026. https://cali-graf.com/guides/domestic-content-residential-solar-2026/